wwwwww..wwiinneemmaattee..ccoomm Rack Split Cooling System Installation, Operation & Care Manual WM-2500SSR WM-4500SSR WM-6500SSR wwwwww..
- 9 -3) Press up/down keys / to scroll to the required parameter with
- 10 -Care Guide In general, always unplug system or disconnect pow
- 11 -User’s Troubleshooting This Troubleshooting Chart is not prepar
- 12 -high or not cooling and running continually b. Cellar too lar
- 13 -fan running but condensing unit not running b. Failed components
- 14 -Installer’s Instruction Federal law requires that WINE-MATE spl
- 15 -CAUTION: Liquid and suction line locations may differ from what
- 16 - Fig. 4 WM-250~450SCU Condensing Unit Fig. 5 WM-650SCU Conde
- 17 - Fig. 6 Liquid F
- 18 -1) Place the condensing units WM-250~650SCU in a properly ventil
- 1 -Important Safety Information WARNING: • Do not use a ground fau
- 19 -4. Temperature Controller and Air Probe 1) The temperature co
- 20 -2) Use of the encapsulated pressure control (if applicable) Fi
- 21 -• The line connection sizes of liquid filter & indicator, t
- 22 -1) Evacuate the system; both discharge and suction valves must b
- 23 -8) If the superheat is low, then decrease the evaporator suction
- 24 -High superheat and normal subcooling 13) Low suction pressure an
- 25 -Electrical Wiring Diagrams CAUTION: • Hidden lines are the fi
- 26 - Fig. 17 WM-6500SSR Electrical Wiring Diagram Fig. 18 Low A
- 27 - Fig. 19 Low Ambient Temperature WM-6500SSR-LA Electrical Wirin
- 28 -Customer Support If you need further assistance, please contact
- 2 -Table of Contents Cellar Construction.…………………………….……………..3 Fea
- 29 -Warranty Thank you for choosing a Vinotemp cooling unit. Ple
- 30 -VINOTEMP will, at its discretion, repair or replace the unit and
- 3 -Cellar Construction This is only a guide and shall be considered
- 4 -Features and Specifications • Wine-Mate rack split cooling syst
- 5 -NOTE: To prepare rough-in, leave minimum 4” clearances for electr
- 6 -Temperature and Humidity 1. Use of the controller Fig. 2 Tempe
- 7 -4) Alarm Signals The alarm codes are described as follows. MES
- 8 -5. How to calibrate the air temperature probe If the actual cel
Comments to this Manuals