INSTALLATION
• Remove all packing material before using your wine cooler.
• IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately
24 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water and a soft cloth.
• This unit is designed for freestanding and built-in installation and indoor use only. Position the unit
in a dry and well-ventilated place. Avoid placing the wine cooler near any source of heat or
moisture, or in direct sunlight. Do NOT install the unit in a location with an ambient temperature
that will fall below 60°F.
• For freestanding installation, 5” of space at the back and both sides are suggested to ensure
proper air circulation to cool the compressor and condenser.
• For built-in installation, leave a ¼” (6.35mm) space on each side and at the top, and 1-2” at the
back of the wine cooler to ensure proper air circulation to cool the compressor and condenser.
Also, be sure to not obstruct the front exhaust vent with anything as this may prevent the unit from
performing properly.
• Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To
level the wine cooler, adjust the front leveling legs at the bottom of the wine cooler.
• For best performance it is recommended that you install the appliance in a location with an
ambient temperature between 60°-90°F. If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected.
• It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
• Avoid locating the unit in moist areas.
• Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.
OPERATING YOUR WINE COOLER
CONTROLS
POWER
To control this appliance turn on/off. To turn OFF the appliance, touch the
key for 5 seconds.
LIGHT
To control the inner light turn on/off.
UP
Used to raise (warm) the set temperature by 1°C or 1ºF.
8
WWW.VINOTEMP.COM
(16 pages)
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals