Vinotemp VT-ODSBREF Operations Instructions download pdf (Page 7)

17621 South Susana Road, Rancho Dominguez, California 90221

INSTALLATION INSTRUCTIONS

Before Using Your Unit

• Remove the exterior and interior packing.

• Check to be sure you have all of the following parts:

• 2 Glass Shelves

• 2 Crisper Drawers

• 1 Crisper Glass Lid

• 1 Instruction Manual

• 4 Casters with Brakes

• Before connecting the unit to the power source, let it stand upright for approximately 2

hours. This will reduce the possibility of a malfunction in the cooling system from

handling during transportation.

• Clean the interior surface with lukewarm water using a soft cloth.

BUILT - IN INSTALLATION

• This unit has been designed for either freestanding or built-in installation.

• When built - in, it does not require additional clearance for top, sides or rear. However,

the front grill must not be obstructed.

OUTDOOR USE

• High ambient temperature over 110º F (43.4º C) may reduce the unit's ability to reach

low inner temperatures.

• The same applies if the ambient temperature drops below 40º F (4.4º C).

• It is recommended that the unit be shut off in temperature outside these limits.

CASTERS INSTALLATION

• Install the four casters provided into the unit’s bottom four threaded holes supplied.

• In order to release or lock the brake, follow the guide.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Vinotemp VT-ODSBREF Operations Instructions Page 7