Vinotemp VT-WINEDISP4 Operations Instructions download pdf (Page 9)

1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1

i n f o @ v i n o t e m p . c o m

Attaching and Removing Wine Bottles

1. Unscrew lower part of bottle fix nut and place it on the neck of desired wine bottle.

2. Slide bottle upward, with gas and wine tube inside the bottle.

3. Fit bottle mouth into silicon plug. If bottle mouth is larger, lift upper part of bottle fix nut

to free silicon plug completely and ease bottle mouth into the silicon plug first.

4. Tighten lower part of bottle fix nut to the upper part.

5. Press the dispensing button to allow wine out and check to see if gas leakage will occur.

(Reconnect tighter if needed so gas does not escape.)

6. Place wine fully in refrigerated cabinet and close door.

Once the wine dispenser is positioned and plugged in, turn the power on.

Dispensing Wine

The wine dispenser features two sets of two dispensing buttons, each positioned directly above its

corresponding wine bottle spout. The two dispensing button options are:

Press and hold the button over the desired spout to begin dispensing wine into

your glass. Wine will continue to be dispensed until the button is released.

Press the button to dispense wine in 1oz increments. Press it once to dispense

1oz, twice to dispense 2oz, and so forth.

Resetting the 1 oz. portion control setting: The 1 oz. preset portion control setting can be

reset by the user. To set the portion control, press and hold the button until the display

shows “H2” and the previously set portion amount begins to flash. Using the or

buttons, you can increase or decrease the portion control settings in 1 oz. increments until

you reach your desired setting.

Calibrating the portion: If the amount of wine dispensed varies, additional calibration may be

used to correct the dispensed portion of wine. To calibrate the portion control setting, press

and hold the button until the display shows “H3” and the previously set portion control

amount begins to flash. Using the or buttons, you can increase or decrease the portion

control settings if necessary. Once you have checked the portion control setting, press the

button to dispense wine and verify the amount poured. Note: You may need to repeat this

procedure several times until the correct portion is dispensed.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Vinotemp VT-WINEDISP4 Operations Instructions Page 9