Vinotemp 2500CD Service Manual download pdf (Page 10)

- 9 -

4) Removing the Electronic Controller

Figure 2-7

Figure 2-8

1. Unplug the WINEMATE cooling unit or disconnect power.

2. Remove WINEMATE cooling unit from the enclosure.

3. Remove the top large styrofoam cover.

4. Disconnect all three connectors for the electronic controller.

5. Unsnap the thin plastic cover off the front of the electronic controller.

6. Remove the two screws from the front of the electronic controller.

7. Locate the retainer just inside the front panel going around the outside of

the electronic controller. While squeezing both tabs of the retainer, push

the electronic controller out of the opening.

5) Removing the Thermistor

1. Unplug the WINEMATE cooling unit or disconnect power.

2. Remove the WINEMATE cooling unit from the enclosure opening.

3. Remove the outer cover.

4. Remove the top large styrofoam cover.

5. Disconnect the thermistor with connector from the electronic controller.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

No comments

Vinotemp 2500CD Service Manual Page 10