WINE-MATE Cooling Unit Service Manual VINO-1500HZD VINO-2500HZD Vinotemp International Inc. wwwwww..vviinnootteemmpp..ccoomm wwwwww..wwiinn
- 9 -4) Removing the Electronic Controller Figure 2-7
- 10 -6. Remove the thermistor from the mounting clip o
- 11 -1. Unplug the WINEMATE cooling unit or disconnec
- 12 -Note: Any time the sealed system is accessed the
- 13 -3. Servicing and Diagnosis This section ins
- 14 -D. Fan Wires: black shrunk wire from the fan term
- 15 -A. Resistance 1. Unplug WINEMATE cooling unit
- 16 -3) Start Relay A start relay’s function is to e
- 17 -electronic controller will turn on the compressor
- 18 -3. Set the voltmeter to the AC 200 scale. 4. T
- 1 -SAFETY INFORMATION
- 19 -1. The WINEMATE unit needs to be plugged in and
- 20 - Figure 3-5B (5 button controller) III. Troub
- 21 -starting , but temperature rising high 3. Temper
- 22 -too long b. Cellar too large c. Ambient temper
- 23 -condensate c. Evaporator air flow restriction d.
- 24 -4. Customer Support If you still have problems,
- 25 -5. Warranty I. Limited Warranty VI
- 26 -II. Limitation of Implied Warranty VINOTEMP’S SO
- 2 -TABLE OF CONTENTS 1. Introduction…………………………………
- 3 -1. Introduction VINOTEMP assumes no responsibil
- 4 -• Use dry nitrogen to purge the system. • Do not
- 5 -2. Component Information and Access This sectio
- 6 -II. Component Access 1) Removing the Outer Cover
- 7 - Figure 2-3 Figure 2-4
- 8 -3) Removing the Fan Plate 1. Disconnect the powe
Comments to this Manuals